Blog

Get started in 3 minutes! Quick start tutorial for barcode ribbon slitter

delish machine09. June, 20250

The following is a 3-minute quick start barcode ribbon slitting machine operation guide to help you complete the slitting task efficiently:

1. Safety Preparation (30 seconds)

• Wear gloves to avoid scratches.

• Inspect the power cord and machine casing to ensure there is no damage.

• Confirm that the work surface is flat and the machine is placed securely.

Get started in 3 minutes! Quick start tutorial for barcode ribbon slitter

2. Installation Materials (1 min)

• Unwinding Reel: Attach the large ribbon/barcode label roll to the unwinding reel, noting the orientation (ribbon coating side down, label side up).

• Reel: Install an empty paper core or reel and fix it with a circlip.

• Threading path: Guides the material through the tension roller (if any) and the guide rod to ensure that the material is flat and free of skew.

3. Parameter setting (30 seconds)

• Width setting: Enter the slitting width (e.g. 50mm) via the control panel, or manually adjust the blade spacing.

• Length setting: If you need to cut the length to the exact length, enter the target length (e.g. 100m/roll).

• Tension adjustment: Gently turn the tension knob to moderate (if it is too tight, it will break, and if it is too loose, it will slip).

Get started in 3 minutes! Quick start tutorial for barcode ribbon slitter

4. Trial Cutting and Adjustment (30 seconds)

• Press the Jog/Try Cut button to check if the slitting edge is flat.

• Observe whether the winding is neat, if there is an offset:

◦ Adjust the position of the guide rod.

◦ Fine-tune tension or unwinding balance.

5. Run (30 seconds)

• Press the Start button to gradually increase the speed after running at low speed.

• Monitor the slitting process and remove debris in a timely manner (to avoid accumulation).

Get started in 3 minutes! Quick start tutorial for barcode ribbon slitter

6. Wrapping Up (30 seconds)

• After the slitting is completed, stop the machine and then cut the material.

• Remove the slitted rolls and label them with specifications.

• Clean the blades and rollers (alcohol swab wipe).

Quick look at frequently asked questions

• Edge burrs → Check if the blade is sharp, replace or sharpen.

• Uneven winding → Adjust material path or tension.

• Machine squeak → Stop the machine immediately and check the bearings or transmission parts.

By following the steps above, you can quickly complete the basic slitting task. Please refer to the equipment manual for detailed parameters (e.g. cutter pressure, speed, etc.). Safety first, try high-speed mode when you're proficient!

Related Blogs

Related Product